Toyota Corolla (E170): Doors

Share this page:

Other materials:

Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicle’s ...

Stabilizer bar front
Replacement Hint: components: 1. Remove front wheel 2. Remove front stabilizer link assy lh Remove the 2 nuts and stabilizer bar link. Hint: if the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud. 3. Remove front stabilizer link assy rh Hint: ...