Toyota Corolla (E120): Disposal
1. Dispose shock absorber assy front lh
- fully extend the shock absorber piston rod.
- using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.
Caution
:
- when drilling, chips may fly out, work carefully.
- The gas is colorless, odorless and non–poisonous.
Other materials:
Adjustment
1. Put vehicle these conditions
tire inflation pressure is the specified value .
start the engine.
2. Adjust fog light aim
The fog light aim can be adjusting by moving the aiming
screw in the vertical direction.
Hint:
the optical aim moves upward when turning a scr ...
On–vehicle inspection
1. Inspect front axle hub bearing
remove the front wheel.
separate the front disc brake caliper assy .
remove the front disc.
inspect the bearing backlash.
Using a dial indicator, check the backlash near the
center of the axle hub.
Maximum: 0.05 Mm (0. ...
Under hood
General maintenance
1. General notes
maintenance requirements vary depending on the country.
Check the maintenance schedule in the owner’s manual supplement.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle using either miles
driv ...