Toyota Corolla (E120): Differential case assy (c59)

Share this page:

Other materials:

Ecm (1zz–fe)
Replacement 1. Disconnect battery negative terminal 2. Remove glove compartment door assy 3. Remove ecm Remove the 2 clips using a clip remover. Then, open the cover. Disconnect the 4 ecm connectors.  remove the wire harness from the wire harness clamp. Remove the 2 ...

Inspection procedure
Hint: if dtcs p0115, p0116, p0117, p0118 and p0125 are output simultaneously, the engine coolant temperature sensor circuit may be open or short. Perform the troubleshooting of dtc p0115, p0117 or p0118 first. Read freeze frame data using the hand-held tester or the obd ii scan to ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...