Toyota Tacoma manuals

Toyota Corolla Repair Manual: Diagnostic trouble code chart

Toyota Corolla Repair Manual / Diagnostics / Sfi system / Diagnostic trouble code chart

Hint

: as for the vehicle for mexico, refer to repair manual 2003 corolla (pub. No. Rm938u).

Parameters listed in the chart may not be exactly the same as your readings due to the type of instrument or other factors.

If a malfunction code is displayed during the dtc check in the check mode, check the circuit for the codes listed in the table below. For details of each code, refer to the ’’’’ under the respective ’’dtc no.’’ In the dtc chart.

*1: ” ○” ... Mil is illuminated, ”—”

*1: ” ” ... Mil is illuminated, ”” ... Mil is not illuminated.

*2: Mil is illuminated or blinks *3: this dtc is indicate a malfunction related to primary circuit.

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions. & ...

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip d ...

Other materials:

Entire combination meter does not operate
Wiring diagram Inspection procedere 1 Check fuse Check that continuity exists of dome fuse.  check that continuity exists of gauge fuse.  check that continuity exists of am1 fuse. 2 Inspect combination meter assy Check continuity.  Disconnect the ”c9 ...

Checking the messages
1 Display the “Message Inbox” screen. 2 Select the desired message from the list. 3 Check that the message is displayed. 1 E-mails: Select “Mark Unread” or “Mark Read” to mark mail unread or read on the message inbox screen. This function is available when “Update Message Read Status on Phone ...

Rear suspension
Preparation Sst Recomended tools Equipment Tire & wheel Preparation Equipment ...

© 2011-2024 Copyright www.tcorolla.net