Toyota Corolla (E170): Detailed Bluetooth® system settings

You can confirm and change the detailed Bluetooth® settings.

Share this page:

Other materials:

Inspection procedure


Hand–held tester: 1 Check operation of stop light Check if the stop lights go on and off normally when the brake pedal is depressed and released. 2 Inspect stop light switch assy Check the resistance between the terminals when the switch is turned on and off. Standard: ...

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

Inspection procedure
1 Inspect ecm(+b voltage) Turn the ignition switch on.  measure the voltage between the terminals of the e4 and e6 ecm connectors. Standard: 2 Check harness and connector(ecm – body ground) Disconnect the e4 ecm connector. check the resistance between the wire ...