Toyota Corolla (E120): Definition of terms

Term

Definition
Monitor description Description of what the ecm monitors and how it detects malfunction (monitoring purpose and its details).
Related dtcs Diagnostic code
Typical enabling condition Preconditions that allow the ecm to detect malfunction.

With all preconditions satisfied, the ecm sets the dtc when the monitored value(s) exceeds the malfunction threshold(s).
Sequence of operation The priority order that is applied to monitoring, if multiple sensors and components are used to detect the malfunction.

While another sensor is being monitored, the next sensor or component will not be monitored until the previous monitoring has concluded.
Required sensor/components The sensors and components that are used by the ecm to detect malfunction.
Frequency of operation The number of times that the ecm checks for malfunction per driving cycle.
  • Once per driving cycle” means that the ecm detects malfunction only one time during a single driving cycle.
  • Continuous” means that the ecm detects malfunction every time when enabling condition is met.
Duration The minimum time that the ecm must sense a continuous deviation in the monitored value(s) before setting a dtc. This timing begins after the ”typical enabling conditions” are met.
Malfunction thresholds Beyond this value, the ecm will conclude that there is malfunction and set a dtc.
Mil operation Mil illumination timing after a defect is detected.
  • Immediately” means that the ecm illuminates the mil the instant the ecm determines that there is malfunction.
  • 2 Driving cycle” means that the ecm illuminates the mil if the same malfunction is detected again in the 2nd driving cycle.
    Share this page:

    Other materials:

    Inspection
    1. Inspect front seat inner belt assy lh When fastening the seat belt (buckle switch on).  Inspect the continuity and resistance between the terminals. Standard: If the result is not as specified, replace the inner belt. When releasing the seat belt (buckle switch ...

    Replacement
    1. Remove battery 2. Remove battery carrier Remove the 4 bolts and battery carrier. 3. Disconnect floor shift cable transmission control shift Remove the nut from the control shaft lever.  disconnect the control cable from the control shaft lever.  remove the clip a ...

    Circuit description
    The intake air temperature (iat) sensor, mounted on the mass air flow (maf) sensor, monitors the intake air temperature. The iat sensor has a thermistor that varies its resistance depending on the temperature of the intake air. When the air temperature is low, the resistance in the thermisto ...