Toyota Corolla (E170): Correct driving posture

1 Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. 2 Adjust the seat so that you can depress the pedals fully and so that your arms bend slightly at the elbow when gripping the steering wheel. 3 Lock the head restraint in place with the center of the head restraint closest to the top of your ears. 4 Wear the seat belt correctly.

Correct use of the seat belts

    Share this page:

    Other materials:

    Circuit description
    In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...

    Rear axle beam assy
    Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

    Temporarily engaged gear steps selection mode in the D position
    To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces. 1 ...