Toyota Corolla (E120): Cooling system

Share this page:

Other materials:

Inspection procedure
1 Inspect ecm(+b voltage) Turn the ignition switch on.  measure the voltage between the terminals of the e4 and e6 ecm connectors. Standard: 2 Check harness and connector(ecm – body ground) Disconnect the e4 ecm connector. check the resistance between the wire ...

Rear axle beam assy
Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using hand–held tester. 1 Inspect brake actuator assy Select the datalist mode on the hand–held tester.  check the operation sound of the abs pump motor when operat ...