Toyota Corolla (E120): Cooling fan system

Share this page:

Other materials:

On–vehicle inspection
1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...

Pre–check
1. Srs warning light check Turn the ignition switch to the on position and check that the srs warning light lights up. check that the srs warning light goes out after approx. 6 Seconds. Hint: when the ignition switch is at on and the srs warning light remains on or flashes, the ...

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...