Toyota Corolla (E120): Cooler compressor assy

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Overhaul
Hint: components: 1. Remove front wheel 2. Disconnect front stabilizer link assy lh Remove the nut and disconnect the front stabilizer link assy lh from the shock absorber assy front lh. Hint: if the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the st ...

Precaution
1. Check that the battery cables are connected to the correct terminals. 2. Disconnect the battery cables when the battery is given a quick charge. 3. Do not perform tests with a high voltage insulation resistance tester. 4. Never disconnect the battery while the engine is running. 5. Check that ...