Toyota Corolla (E170) 2014–2019 Owners Manual / Interior features / Connecting Bluetooth® (Multimedia system) / Connecting a Bluetooth® device / Connecting a Bluetooth® audio player
Toyota Corolla (E170): Connecting a Bluetooth® audio player
► Registering an additional device Select “Select Device” on the Bluetooth® audio control screen.
►Selecting a registered device Select “Select Device” on the Bluetooth® audio control screen.
■Reconnecting a Bluetooth® phone
If the system cannot connect due to poor signal strength with the engine switch in ACCESSORY or ON <IGNITION ON> mode, the system will automatically attempt to reconnect.
If the phone is turned off, the system will not attempt to reconnect. In this case, the connection must be made manually, or the phone must be reselected.
Other materials:
Auto connection
To turn auto connection mode on, set “Bluetooth* Power” to on.
When you register a phone, auto connection will be activated. Always set it to
this mode and leave the Bluetooth® phone in a place where a connection can be established.
When the engine switch is turned to ACCESSORY or ON <IG ...
Inspection procedure
1 Check un–lock warning switch assy
Disconnect the key unlock warning switch connector.
check the continuity between the terminals of the key unlock
warning switch connector, as shown in the illustration
and table.
Standard:
2 Check wire harness (tvip ecu unlock warni ...
Check short circuit
If the wire harness is ground shorted as shown in fig. 5,
Locate the section by conducting a resistance check with
the body ground in step (b).
Check the resistance with the body ground.
Disconnect connectors a and c and measure the
resistance between terminals 1 and 2 ...