Toyota Corolla (E120): Components
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage
Turn the ignition switch to on.
measure voltage between terminals 13 (tc) and 4 (cg) of
dlc3.
Ok:
voltage: 10 – 16 v
2 Check harness and connector(between cruise control ecu assy
and dlc3)
Check for open and short circuit in harness ...
Removal & installation and disassembly & re
1. Remove bench type rear seat cushion assy (, 72–8)
2. Remove rear floor service hole cover
3. Work for preventing gasoline from spilling out
start the engine.
after the engine has stopped on the its own, turn the ignition
switch to lock.
4. Disconnect fuel tank main tu ...
Pressing power switch does not start system
Wiring diagram
Inspection procedure
1 Inspect radio receiver assy(+b, acc, gnd)
Check that the continuity between terminals at each
condition, as shown in the chart.
Standard:
Check that the voltage between terminals at each condition,
as shown in the chart.
Standard:
...