Toyota Corolla (E120): Components

Replacement

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect stop lamp switch assy Check that the stop light lights up when brake pedal is depressed and turns off when the brake pedal is released. 2 Inspect skid control ecu terminal voltage(stp terminal) Disconnect skid control ecu connector. measure voltage between termina ...

    Hydraulic test
    1. Perform hydraulic test Measure the line pressure. Notice: Do the test at normal operation atf temperature 50 to 80 °c (122 to 176 °f). The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stopper outsi ...

    Front wheel alignment
    Adjustment 1. Inspect tire 2. Measure vehicle height Vehicle height: Measuring points: a: ground clearance of front wheel center b: ground clearance of lower suspension arm front bolt center c: ground clearance of axle beam set bolt center d: ground clearance of rear wheel center Not ...