Toyota Corolla (E120): Components
Other materials:
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...
Inspection procedure
1 Inspect fuse(ecu–ig fuse)
Remove ecu–ig fuse from the instrument panel j/b.
check continuity of ecu–ig fuse.
Ok:
continuity
2 Inspect battery
Ok:
voltage: 10 – 14 v
3 Inspect skid control ecu connector(ig1 terminal voltage)
In case of using hand–held te ...
Circuit description
The crankshaft position sensor (ne signal) consists of a magnet, iron core
and pickup coil.
The ne signal plate (crankshaft position sensor plate) has 34 teeth and is
installed on the crankshaft. The
ne signal sensor generates 34 signals for each engine revolution. This sensor
monitors a p ...