Toyota Corolla (E120): Components
Other materials:
Inspection procedure
1 Check seat position air bag sensor
Sst 09843–18040
Turn the ignition switch to on, and wait at least for 20 seconds.
clear the dtc stored in memory .
turn the ignition switch to lock, and wait at least for 20
seconds.
turn the ignition switch to on, and wait at ...
On–vehicle inspection
1. Inspect drive belt
Visually check the belt for excessive wear, frayed cords,
etc.
If any defect is found, replace the drive belt.
Hint:
cracks on the rib side of a belt are considered acceptable. If the
missing chunks from the ribs are found on the belt, it should be
replaced.
2 ...
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...