Toyota Corolla (E120): Components

Overhaul

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Terminals of ecu
    Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

    Valve clearance
    Adjustment 1. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 2. Disconnect engine wire Remove the 5 clamps from the 5 clamp brackets. Disconnect the 4 ignition coil connectors. Remove the bolt and nut installing the engine wire ...