Toyota Corolla (E120): Components

Overhaul

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

    Data list/active test
    1. Data list Hint: using the data list displayed by the hand–held tester or the obd ii scan tool, you can read the value of the switches, sensors, actuators and so on without parts removal. Reading the data list as a first step of troubleshooting is one method to shorten diagnostic time. ...

    Inspection procedure
    1 Check harness and connector(transmission control switch – body ground) Disconnect the transmission control switch connector of shift lever assy. measure the resistance according to the value(s) in the table below. Standard: 2 Inspect transmission control switch M ...