Toyota Corolla (E120): Components
Other materials:
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...
Windshield wipers and washer
Operating the wiper lever
The wiper operation is selected by moving the lever as follows. When intermittent
windshield wiper operation is selected, the wiper interval can be also adjusted.
1 Intermittent windshield wiper operation
2 Low speed windshield wiper operation
3 High speed windshield ...