Toyota Corolla (E120): Clutch switch circuit

Share this page:

Other materials:

Inspection
1. Cooler thermistor no.1 Check resistance between terminals 1 and 2 of cooler thermistor no. 1 At each temperature, as shown in the chart. Resistance: If resistance value is not as specified, replace the sensor. 2. Cooler and accessory assy Inspect blower switch contin ...

Changing the passkey
1 Select “Passkey” using . 2 Input a 4 to 8-digit passkey using . Input the number 1 digit at a time. 3 When the entire number to be registered as a passkey has been input, press again. If the passkey to be registered has 8 digits, pressing again is not necessary. ...

Inspection procedure
1 Check connector Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the combination meter connector and the airbag sensor assy center connectors. Ok: the connectors are connected. 2 Check combination ...