Toyota Corolla (E120): Clutch pedal sub–assy (mtm)

Share this page:

Other materials:

Inspection procedure
1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...

Lubrication system
On–vehicle inspection 1. Check engine oil level  after warming up the engine and then 5 minutes after the engine stops, oil level should be between the ”l” and ”f” marks on the oil level gage. If low, check for leakage and add oil up to the ”f” mark. Notice: do not ...