Toyota Corolla (E120): Circuit descriptionCircuit description

The p/t squib (lh) circuit consists of the airbag sensor assy center and seat belt pretensioner (lh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0138/72 is recorded when a b+ short is detected in the p/t squib (lh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

    Shifting the shift lever
    Vehicles without a smart key system: While the engine switch is in the “ON” position, depress the brake pedal and move the shift lever. Vehicles with a smart key system: While the engine switch is in IGNITION ON mode, depress the brake pedal and move the shift lever. When shifting the ...

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...