Toyota Corolla (E120): Circuit description

This circuit carries the set/coast, res/acc and cancel signals (each voltage) to the cruise control ecu assy.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Removal & installation and disassembly & reassembly
    1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...

    Overhaul
    Notice: when using a vise, do not over tighten. When installing, coat the parts indicated by the arrows with power steering fluid . 1. Remove front wheel rh 2. Drain power steering fluid 3. Remove engine under cover rh 4. Remove fan and generator v belt 5. Disconnect oil reservoir to ...

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...