Toyota Corolla (E120): Circuit description
The srs warning light is located on the combination meter.
When the srs is normal, the srs warning light lights up for approx. 6 Seconds after the ignition switch is turned from the lock position to on position, and then turns off automatically.
If there is a malfunction is the srs, the srs warning light lights up to inform the driver of the abnormality.
When terminals tc and cg of the dlc3 are connected, the dtc is displayed by blinking the srs warning light.
Wiring diagram
Srs warning light circuit malfunction (does not light
up, when ignition switch is turned to on)
Other materials:
Overhaul
Hint:
installation is in the reverse order of the removal. But the
installation is indicated only when it has a
point.
In the rh side, work in the same procedure as in the lh side.
1. Remove front armrest assy lh
Using a screwdriver, remove the front armrest.
Hint:
tape the ...
Registering a Bluetooth® phone for the first time
To use the hands-free system, it is necessary to register a Bluetooth® phone
with the system.
Once the phone has been registered, it is possible to use the hands-free system.
For details about registering a Bluetooth® device
1 Turn the Bluetooth® connection setting of your cellular phone on. ...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...