Toyota Corolla (E120): Circuit description

The p squib (2nd step) circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b1186/58 is recorded when an open is detected in the p squib circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Safe Exit Assist
    The safe exit assist is a system that uses rear side radar sensors installed on the inner side of the rear bumper to help occupants judge if an approaching vehicle or bicycle may collide with a door when opening it or cancel opening of the door, to reduce the possibility of a collision. WARNING ■C ...

    Stabilizer bar front
    Replacement Hint: components: 1. Remove front wheel 2. Remove front stabilizer link assy lh Remove the 2 nuts and stabilizer bar link. Hint: if the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud. 3. Remove front stabilizer link assy rh Hint: ...

    Inspection
    1. Thermostat Hint: the thermostat is numbered with the valve opening temperature. Immerse the thermostat in water and gradually heat the water.  check the valve opening temperature. Valve opening temperature: 80 to 84 c (176 to 183 f) Hint: if the valve opening temperatur ...