Toyota Corolla (E120): Circuit description
The d squib (2nd step) circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy.
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b1183/22 is recorded when a b+ short is detected in the d squib (2nd step) circuit.
Wiring diagram
Other materials:
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...
Window lock switch
Press the switch to lock the passenger window switches.
Use this switch to prevent children from accidentally opening or closing a passenger
window.
■The power windows can be operated when
► Vehicles without a smart key system
The engine switch is in the “ON” position.
υ ...
Inspection procedure
1 Input signal check
See input signal check on page 05–745.
check indicator light operation when driving with vehicle
speed above 40 km/h (25 mph), and with vehicle speed
below 40 km/h (25 mph).
Ok:
vehicle speed above 40 km/h (25 mph):
indicator light blinks
vehicle speed be ...