Toyota Corolla (E120): Circuit description

The side airbag sensor assy (rh) circuit consists of the diagnosis circuit and lateral deceleration sensor, etc.

It receives signals from the lateral deceleration sensor, judges whether or not the srs must be activated, and detects diagnosis system malfunction.

Dtc b1140/32 is recorded when occurrence of a malfunction in the side airbag sensor assy (rh) is detected.

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Malfunction in fuel receiver gauge
    Wiring diagram Inspection procedere 1 Inspect fuel sender gage assy Disconnect the connector fuel sender gauge. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously. S ...

    Driving mode select switch
    The driving modes can be selected to suit driving condition. Selecting a drive mode Operate the driving mode select switch forward or backward to select the desired driving mode on the multi-information display. Normal mode Provides an optimal balance of fuel economy, quietness, and dynamic perf ...

    Skid control sensor
    Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...