Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Airbag sensor assy malfunction / Circuit description
Toyota Corolla (E120): Circuit description
The airbag sensor assy center consists of a airbag sensor assy center, safing sensor, drive circuit, diagnosis circuit and ignition control, etc.
It receives signals from the airbag sensor, judges whether or not the srs must be activated, and detects diagnosis system malfunction.
Dtc b1100/31 is recorded when occurrence of a malfunction in the airbag sensor assy center is detected.
Inspection procedure
Hint
: when a malfunction code other than code b1100/31 is displayed at the same time, first repair the malfunction indicated by the malfunction code other than code b1100/31.
Other materials:
On–vehicle inspection
1. Washer motor
Operation check
pour the water into the washer jar with the washer
motor and the pump installed to the washer jar assy.
Connect the battery (+) to terminal 2 of the washer
motor and the pump, the battery (–) to terminal 1 of
the washer motor and the pump ...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...
Overhaul
Hint:
overhaul the rh side by the same procedure as the lh side.
1. Remove front wheel
2. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
3. Remove front disc brake cylinder sub–assy
Remove the union bolt and gasket ...