Toyota Corolla (E120): Circuit description

The p/t squib (rh) circuit consists of the airbag sensor assy center and seat belt pretensioner (rh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0132/61 is recorded when a ground short is detected in the p/t squib (rh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Removal & installation and disassembly & re
    1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...

    Replacement
    1. Remove engine under cover rh 2. Drain coolant 3. Remove front wheel rh 4. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 5. Remove fan and generator v belt Turn the v–ribbed belt tensioner slowly clockwise and loosen it. Then, remove ...

    Circuit description
    The srs warning light is located on the combination meter. When the srs is normal, the srs warning light lights up for approx. 6 Seconds after the ignition switch is turned from the lock position to on position, and then turns off automatically. If there is a malfunction in the srs, the srs ...