Toyota Corolla (E120): Circuit description

The p/t squib circuit (rh) consists of the airbag sensor assy center and seat belt pretensioner (rh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0131/64 is recorded when an open is detected in the p/t squib (rh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Stopping the engine
    1 Stop the vehicle. 2 Continuously variable transmission: Shift the shift lever to P. Manual transmission: Shift the shift lever to N. 3 Set the parking brake. 4 Press the engine switch. 5 Vehicles without a multi-information display: Release the brake pedal (continuously variable transmission ...

    Inspection procedure
    1 Inspect transmission wire(s2) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

    Hood
    Release the lock from the inside of the vehicle to open the hood. 1 Pull the hood lock release lever. The hood will pop up slightly. 2 Pull up the auxiliary catch lever and lift the hood. 3 Hold the hood open by inserting the support rod into the slot. CAUTION ■Pre-driving check C ...