Toyota Corolla (E120): Circuit description

The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0118/46 is recorded when a b+ short is detected in the side squib (lh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Rear axle beam assy
    Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

    Circuit description
    Refer to dtc p0130 Dtc no. Dtc detecting condition Trouble area P0134 After engine is warmed up, heated oxygen sensor (bank 1 sensor 1) output does not indicate rich (greater than 0.45 V) even once when conditions (a), (b), (c), (d) and (e) continue for ...

    Inspection procedure
    1 Input signal check See input signal check on page 05–745. check indicator light operation when driving with vehicle speed above 40 km/h (25 mph), and with vehicle speed below 40 km/h (25 mph). Ok: vehicle speed above 40 km/h (25 mph): indicator light blinks vehicle speed be ...