Toyota Corolla (E120): Circuit description

The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0117/45 is recorded when a ground short is detected in the side squib (lh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Bluetooth®
    ■When using the Bluetooth® audio system ●In the following situations, the system may not function. • The portable player does not support Bluetooth® • The cellular phone is located outside the service area • The Bluetooth® device is switched off • The Bluetooth® device h ...

    Auto connection
    To turn auto connection mode on, set “Bluetooth* Power” to on. When you register a phone, auto connection will be activated. Always set it to this mode and leave the Bluetooth® phone in a place where a connection can be established. When the engine switch is turned to ACCESSORY or ON <IG ...

    Ecm (1zz–fe)
    Replacement 1. Disconnect battery negative terminal 2. Remove glove compartment door assy 3. Remove ecm Remove the 2 clips using a clip remover. Then, open the cover. Disconnect the 4 ecm connectors.  remove the wire harness from the wire harness clamp. Remove the 2 ...