Toyota Corolla (E120): Circuit description
The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0113/42 is recorded when a b+ short is detected in the side squib (rh) circuit.
Wiring diagram
Other materials:
Inspection procedure
1 Input signal check
See input signal check on page 05–745.
check the indicator light operation when each of the set/
coast, resume/accel and cancel is turned on.
Ok:
set/coast, resume/accel switch:
the signals shown in the table on the left should be
output when each switch is ...
On–vehicle inspection
1. Inspection throttle body idle speed control valve assy
Notice:
it is impossible to check the resister value and the operation
of isc valve by itself, because the isc valve
has an ic circuit inside it, which transforms the duty
signal from the ecm to the derive signal.
After check ...
Removal & installation and disassembly & reassembly
1. Remove oxygen sensor
Remove a clip and tear off the floor mat.
disconnect a oxygen sensor connector.
Remove the oxygen sensor.
2. Remove tail pipe assy
Remove 2 bolts, 2 springs and tail pipe assy.
3. Remove floor panel brace front
Remove 2 nuts and the ...