Toyota Corolla (E120): Circuit description

The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0112/41 is recorded when ground short is detected in the side squib (rh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Overhaul
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. In the rh side, work in the same procedure as in the lh side. 1. Remove front armrest assy lh Using a screwdriver, remove the front armrest. Hint: tape the ...

    Inspection procedure
    1 Check un–lock warning switch assy Disconnect the key unlock warning switch connector.  check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table. Standard: 2 Check wire harness (tvip ecu unlock warni ...

    On–vehicle inspection
    1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...