Toyota Corolla (E120): Circuit description

The p squib circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0108/52 is recorded when a b+ short is detected in the p squib circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Adjustment
    1. Check and adjust brake pedal height Inspect brake pedal height. Pedal height from asphalt sheet: m/t: 134.9 – 144.9 Mm (5.311 – 5.703 In.) A/t: 136.0 – 146.0 Mm (5.353 – 5.747 In.)  Disconnect the connector from the stop lamp switch.  Remove the stop lamp ...

    Checking and replacing fuses
    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Checking and replacing fuses 1. Turn the engine switch off. 2. Open the fuse box cover. Engine compartment: type A fuse box Push the tabs in and lift the lid off. E ...

    Front axle lh hub bolt
    Replacement Hint: components: 1. Remove front wheel 2. Separate front disc brake caliper assy lh 3. Remove front disc 4. Remove front axle lh hub bolt Using sst and a hammer handle or an equivalent, remove the lh hub bolt. Sst 09628–10011 5. Install front axle lh hub bolt ...