Toyota Corolla (E120): Circuit description

The p squib circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0107/51 is recorded when ground short is detected in the p squib circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Inspection procedure
    Hint: troubleshoot each trouble symptom in accordance with the chart below. 1 Clear dtc Connect the hand–held tester or the obd ii scan tool to the dlc 3.  turn the ignition switch on and push the hand–held tester or the obd ii scan tool main switch on.  read the dtc . ...

    Checking and adding the brake fluid
    ■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reservoir cap. 4. Add brake fluid slowl ...

    If the engine will not start
    If the engine will not start even though correct starting procedures are being followed, consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be sufficient fuel in the ...