Toyota Corolla (E120): Circuit description

The sensor check circuit detects abnormalities in the speed sensor signal which cannot be detected with the dtc check.

Connecting terminals ts and cg of the dlc3 starts the check.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Back up lamp assy lh
    Replacement 1. Remove back up lamp assy lh Remove the service hole cover.  remove the 2 nuts and disconnect the connector. Using a mouldingremover, remove the 2 clips and back up light assy lh. 2. Install back up lamp assy lh Set the 2 clips on the back up ligh ...

    Inspection
    1. Thermostat Hint: the thermostat is numbered with the valve opening temperature. Immerse the thermostat in water and gradually heat the water.  check the valve opening temperature. Valve opening temperature: 80 to 84 c (176 to 183 f) Hint: if the valve opening temperatur ...

    Circuit description
    The door key lock and unlock switch is built in the door lock motor. Wiring diagram Inspection procedure 1 Check door lock 2 Check wire harness (tvip ecu  door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the t ...