Toyota Corolla (E120): Circuit description
If the engine coolant temperature (ect) does not reach 75°c (167°f) despite sufficient warm – up time has elapsed.
Dtc no |
Dtc detection condition |
Trouble area |
P0128 | Condition (a), (b) and (c):
|
|
Monitor description
The ecm estimates the engine coolant temperature (ect) based on starting temperature, engine loads, and engine speeds. The ecm then compares the estimated ect with the actual ect. When the estimated ect reaches 75 c (167 f) the ecm checks the actual ect. If the actual ect is less than 75 c (167 f), the ecm will interpret this as a fault in the thermostat or engine cooling system or thermostat and set a dtc.
Monitor strategy
Typical enabling conditions
Typical malfunction thresholds
Component operating range
Monitor result (mode 06 data)
Refer to page 05–27 for the detailed information on checking monitor status.
Other materials:
Unlocking and locking the doors from the outside
◆ Smart key system (if equipped)
Carry the electronic key to enable this function.
1 Grip the driver’s door handle to unlock the door. Grip the passenger’s door
handle to unlock all the doors.* Make sure to touch the sensor on the back of the
handle.
The doors cannot be unlocked for ...
Identification information
Vehicle identification and serial numbers
1. Vehicle identification number
The vehicle identification number is stamped on the vehicle
identification number plate and certification label, as
shown in the illustration.
Vehicle identification number plate
certification label
2. Engine ...
Inspection procedure
1 Check wire harness(airbag sensor assy center – front seat inner
belt assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the front seat inner belt assy ( ...