Toyota Corolla (E120): Cigarette lighter assy

Replacement

Hint: components:

1. Remove floor shift shift lever knob sub–assy (m/t transaxle)

2. Remove console panel upper

3. Remove cigarette lighter cover

  1. Disengage the 2 claws and remove the cigarette lighter cover.

4. Remove cigarette lighter assy

  1. Turn the socket in the circumference direction as shown in the illustration, disengage the claw between the socket and the cigarette lighter bezel stay, and push out the socket to the room side.
  2.  align the socket with the notch on the cigarette lighter bezel stay, remove the cigarette lighter assy to the room side.

5. Install cigarette lighter assy

  1.  align the socket with the notch on the cigarette lighter bezel stay, push the cigarette lighter assy into as hard as possible and install it.
    Share this page:

    Other materials:

    Basic repair hint
    (A) hints on operations 1 Looks Always wear a clean uniform. Hat and safety shoes must be worn. 2 Vehicle protection Set a grill cover, fender cover, seat cover and floor mat before starting the operation. 3 Safe ...

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...

    Replacement
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove luggage compartment door cover 2. Remove rear spoiler  remove the 2 screws.  disconnect the wire harness connector.  put protective tape. &nb ...