Toyota Corolla (E120): Check short circuit
- If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b).
- Check the resistance with the body ground.
- Disconnect connectors a and c and measure the
resistance between terminals 1 and 2 of connector
a and the body ground.
Resistance: 10 kΩ or higher
Hint
: measure the resistance while lightly shaking the wire harness vertically and horizontally. In the case of fig. 6: Between terminal 1 of connector a and body ground " below 1 Ω
between terminal 2 of connector a and body ground " 10 kΩ
or higher therefore, the cause is a short circuit between terminal 1 of connector a and terminal 1 of connector c.
- Disconnect connector b and measure the resistance
between terminal 1 of connector a and the
body ground, and terminal 1 of connector b2 and
the body ground.
In the case of fig. 7: Between terminal 1 of connector a and body ground " 10 kw or higher between terminal 1 of connector b2 and body ground " below 1 w therefore, the cause is a short circuit between terminal 1 of connector b2 and terminal 1 of connector c.
Other materials:
Inspection
1. Inspect driver’s door lock
Inspect the door lock motor operation.
Standard:
If the result is not as specified, replace the door lock assembly.
Inspect the door lock and unlock switch continuity.
Standard:
If the result is not as specified, replace the door lock assem ...
Repair
1. Steering off center repair procedure
Inspect steering wheel off center.
Apply masking tape on the top center of the steering
wheel and steering column upper cover.
Driving the vehicle on a straight line for 100 meters
at a constant speed of 35 mph (56 km/h), and ho ...
Replacement
Hint:
installation is in the reverse order of the removal. But the installation is
indicated only when it has a point.
1. Remove radiator grille sub–assy
Remove the 2 bolts and clip.
using a screwdriver, remove the radiator grille.
Hint:
tape the screwdriver tip before use. ...