Toyota Corolla (E120): Charging system

Share this page:

Other materials:

Inspection procedure
Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Perform active test using the hand–held ...

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

Inspection procedure
1 Check un–lock warning switch assy Disconnect the key unlock warning switch connector.  check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table. Standard: 2 Check wire harness (tvip ecu unlock warni ...