Toyota Corolla (E120): Center stop lamp assy

Replacement

1. Remove package tray trim panel assy (w/o rear spoiler)

2. Remove center stop lamp assy (w/o rear spoiler)

  1. Remove the center stop light assy as shown in the illustlation.

3. Remove center stop lamp assy (w/ rear spoiler)

  1. Remove the 2 screws.
  2.  disconnect the connector and remove the center stop light assy.
    Share this page:

    Other materials:

    Circuit description
    Refer to dtc p0120 Dtc no. Dtc detection condition Trouble area P0121 The following condition is met 4 times. After the vehicle speed has exceeded 19 mph (30 km/h) once, the throttle position sensor output value is out of normal range when the throttle ...

    Disposal
    1. Dispose shock absorber assy front lh  fully extend the shock absorber piston rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, o ...

    Stabilizer bar rear
    Replacement Hint: components: 1. Remove stabilizer bar rear Remove the 2 bolts, nuts and stabilizer bar. 2. Install stabilizer bar rear Install the 2 bolts, nuts and stabilizer bar. Torque: 195 nvm (1,990 Kgf·cm, 144 ft·lbf) Hint: install the stabilizer bar so that the ...