Toyota Corolla (E120): Cd sound skips
Inspection procedure
1 Disc cleaning
- Disk cleaning
- ) if the disk gets dirty, clean the disk by wiping the surface from the center to outside in the radial directions with a soft cloth.
Notice
: do not use a conventional record cleaner or anti–static preservative.
Standard: malfunction disappear.
2 Replace cd with another and recheck
- Replace the cd with another and recheck.
- Check the installation condition of the radio receiver assembly.
Standard: malfunction disappear.
3 Check when this happens
- Check then this happens.
- Check that in what condition (place) noise occurs.
Standard: driving on the bumpy road.
4 Compare it with another car of same model
- Compare it with another vehicle of the same model.
- Compare with the vehicle of the same type which does not have a
trouble to see if there is any
difference in the condition of trouble occurrence.
Standard: no difference found.
Disc cleaning
- Check of radio receiver assembly installation.
- Check the installation condition of the radio receiver assembly.
Standard: installed properly.
6 Did the temperature in the cabin change rapidly?
- Did the temperature in the cabin change rapidly?
- Check whether or not the rapid temperature change occurred in the
cabin.
Standard: the rapid temperature change occurred.
Reference: the rapid temperature change creates condensation inside the cd player, which may disable playing cd.
Check and replace radio receiver assy
Other materials:
Replacement
Hint: components:
1. Precaution
2. Disconnect battery negative terminal
3. Remove seat track upper rail cover rh
4. Remove seat track upper rail cover lh
5. Remove front seat assy lh
6. Remove seat position air bag sensor
Disconnect the connector of the seat position airbag sensor. ...
Adjustment
1. Inspect park/neutral position switch assy
apply the parking brake and turn the ignition switch on.
depress the brake pedal and check that the engine starts only when
the shift lever is set in n or p position
and it does not start in the other position.
check that th ...
Circuit description
The p/t squib (rh) circuit consists of the airbag sensor assy center and seat
belt pretensioner (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0130/63 is recorded when a short is detected in the p/t squib (rh) circuit.
Wiring diagram
...