Toyota Corolla (E120): Cd cannot be taken out
Wiring diagram
Inspection procedure
1 Check if radio auto–search functions properly
- Check if the radio auto–search function properly.
- Perform the auto–research of the radio and check that the
operation is normal.
Standard: malfunction disappear.
2 Press ”eject” and check operation
- Press ”eject”and check the operation.
- Press the cd eject switch of the radio receiver assembly for 2 sec
or more to see if the cd is
ejected.
Standard: cd is ejected.
Reference: if the cd is not ejected, send the vehicle for repair.
Do not try to drag it out by force.
3 Check if a proper cd is inserted
- Check that a proper cd is inserted.
- Check that in what conditions the sound skipping occurs.
Standard: driving on the bad road.
4 Replace cd with another and recheck
- Replace the cd with another and recheck.
- Check the installation condition of the radio receiver assembly.
Standard: installed properly.
5 Inspect radio receiver assy(+b, acc, gnd)
- Check that the continuity between terminals at each condition, as shown in the chart.
Standard:
- Check that the voltage between terminals at each condition, as shown in the chart.
Standard:
Repair or replace harness or connector
Other materials:
Inspection procedure
1 Inspect fuse(ecu–ig fuse)
Remove ecu–ig fuse from the instrument panel j/b.
check continuity of ecu–ig fuse.
Ok:
continuity
2 Inspect battery
Ok:
voltage: 10 – 14 v
3 Inspect skid control ecu connector(ig1 terminal voltage)
In case of using hand–held te ...
Inspection procedure
1 Check hazard warning signal switch assy
Check the hazard warning switch continuity, as shown in
the illustration and table.
Standard:
2 Check turn signal flasher assy
3 Check wire harness (tvip ecu turn signal flasher)
Disconnect the tvip ecu and turn signal flashe ...
Terminals of ecu
1. Inspect integration relay
Disconnect the connector and check the continuity of each terminal of
the disconnected connector.
Standard :
If the result is not as specified, the vehicle’s side may malfunction.
Reconnect the connector and check each terminal.
Standard:
If ...