Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Camshaft position sensor ”a”
circuit
Toyota Corolla (E120): Camshaft position sensor ”a” circuit
Dtc p0340 camshaft position sensor ”a” circuit (bank 1 or single sensor)
Dtc p0341 camshaft position sensor ”a” circuit range/performance (bank 1 or single sensor)
Other materials:
On–vehicle inspection
1. Inspect front axle hub bearing
remove the front wheel.
separate the front disc brake caliper assy .
remove the front disc.
inspect the bearing backlash.
Using a dial indicator, check the backlash near the
center of the axle hub.
Maximum: 0.05 Mm (0. ...
On–vehicle inspection
1. Inspect air–fuel ratio compensation system
Hint:
you can also check the system by choosing ”data monitor”,
then ”o2 sensor output voltage” on the monitor of the
hand–held tester.
Connect the hand–held tester to the terminal 23 (ox1a)
@ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...
Inspection procedure
1 Check operation(overdrive)
Drive the vehicle after the engine warms up.
check that overdrive on e off occurs by an operation of the o/d
switch on–off.
2 Inspect terminal voltage(od)
Remove the cruise control ecu assy with the connector
still connected.
tur ...