Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Camshaft position ”a” actuator circuit

Toyota Corolla (E120): Camshaft position ”a” actuator circuit

Dtc p0010 camshaft position ”a” actuator circuit (bank 1)

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Other functions
■  Switching between outside air and recirculated air modes Press . The mode switches between outside air mode (indicator off) and recirculated air mode (indicator on) each time is pressed. ■ Defogging the windshield Defoggers are used to defog the windshield and front side w ...

Overhaul
1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...