Toyota Corolla (E170): Calling the message sender

Calls can be made to an e-mail/SMS/MMS message sender's phone number.

1 Display the “Message Inbox” screen. 2 Select the desired message.

3 Select 4 Check that the “Call” screen is displayed..

4 Check that the “Call” screen is displayed.

Calling from a number within a message

Calls can be made to a number identified in a message's text area.

1 Display the “Message Inbox” screen. 2 Select the desired message.

3 Select the text area.

4 Select number. corresponding to the desired number.

5 Check that the “Call” screen is displayed.

Calling from the incoming message screen

    Share this page:

    Other materials:

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Removal & installation and disassembly & re
    1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...

    Replacement
    Hint: components: 1. Remove radiator grille sub–assy 2. Remove front bumper cover 3. Remove lh headlamp assy Remove the 3 bolts.  pull out the headlight assy lh forward, then disconnect the bracket of body side. Release the claws and disconnect the connectors as sh ...