Toyota Corolla (E120): Brake pedal sub–assy

Share this page:

Other materials:

Circuit description
The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0110/43 is recorded when a short is detected in the side squib (rh) circuit. Wiring diagram ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Changing engine switch modes
Modes can be changed by pressing the engine switch with brake pedal released. (The mode changes each time the switch is pressed.) OFF*1 The emergency flashers can be used. ACC*2 Some electrical components such as the audio system can be used. "ACCESSORY" will be displayed on the multi-info ...