Toyota Corolla (E140) 2007–2013 Body Repair Manual / Paint coating / Body panel undercoating areas
Toyota Corolla (E140): Body panel undercoating areas
Apply pastar uwe or pastar uc to the chassis, floor underside, sheet metal fitting weld points of the body, and inside of the wheel house to prevent rust and noise, as well as protect the body from flying rocks.
Hint:
- work must be performed while wearing the appropriate protective gear and in a well-ventilated area.
- Apply degreasing agent to a clean cloth and clean any dirt and oil from the application areas.
- Cover the surrounding areas of the application areas with masking paper to avoid coating unnecessary areas.
- Do not coat high temperature areas, such as the tailpipe, or moving parts, such as the driveshaft.
- Do not leave any gaps between the panel joints.
- Apply sealer to the panel joints in advance.
Hint:
- parts coated using the pastar uwe should be left until dry to the touch in a 25 c environment for 60 to 75 minutes. Parts coated using pastar uc should be left until dry to the touch in a 25 c environment for 15 to 30 minutes.
- If using a pastar gun, one spray applies a 0.5 Mm thick coating.
- Pastar uwe: part number v9240-0025 pastar uc: spray type :part
number v9240-0008
aerosol type: part number v9240-0021
Reference
Tthe undercoating should be applied according to the specifications for your country while referring to the notes above.
Other materials:
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the horn button assy.
release the airbag activ ...
Pre–check
1. Srs warning light check
Turn the ignition switch to the on position and check that
the srs warning light lights up.
check that the srs warning light goes out after approx.
6 Seconds.
Hint:
when the ignition switch is at on and the srs warning
light remains on or flashes, the ...
Ecm (1zz–fe)
Replacement
1. Disconnect battery negative terminal
2. Remove glove compartment door assy
3. Remove ecm
Remove the 2 clips using a clip remover. Then, open the
cover.
Disconnect the 4 ecm connectors.
remove the wire harness from the wire harness clamp.
Remove the 2 ...