Toyota Corolla (E140) 2007–2013 Body Repair Manual / Paint coating / Body panel anti-rust agent (wax) application areas

Toyota Corolla (E140): Body panel anti-rust agent (wax) application areas

Apply rustop w to the doors and hood edges (tips of outer panel folded parts) and undersides, areas around hinges, etc.To prevent rust. Coat the undersides of the edges using a nozzle and air gun, and coat the areas around the hinges using a brush.

Hint:

  1.  if rustop is unnecessarily applied to an area, apply degreasing agent to a clean cloth and clean off the rustop immediately.

Silencer sheet installation areas

    Share this page:

    Other materials:

    Inspection procedure
    1 Reconfirm dtc Check the dtc 2 Inspect skid control ecu connector securely connected 3 Inspect skid control ecu connector(ig1 terminal voltage) In case of using hand–held tester:  check the voltage condition output from the ecu displayed on the hand–held tester. O ...

    Heater control & accessory assy
    Replacement 1. Remove console panel upper 2. Remove instrument cluster finish panel 3. Remove heater control & accessory assy Release the 2 fitting claws and pull out the heater control & accessory assy. Using a screwdriver, open the claw of the cable clamp and dis ...

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...