Toyota Corolla (E170): Before towing
The following may indicate a problem with your transmission. Contact your Toyota dealer before towing.
● The engine is running but the vehicle will not move.
● The vehicle makes an abnormal sound.
Other materials:
Overhaul
1. Remove repair service starter kit
Remove the nut, then disconnect the lead wire from terminal
c.
Remove the 2 screws which are used to secure the repair
service starter kit to the starter drive housing.
remove the repair service starter kit.
remove the return ...
Oxygen / af sensor heater monitor
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 9 minutes.
Drive the vehicle at 25 mph (40 km ...
Confirmation driving pattern
Connect the hand–held tester or the obd ii scan tool to the dlc3.
record dtcs and the freeze frame data.
set the check mode using the hand–held tester .
read the value on the misfire counter for each cylinder when
idling. If the value is displayed on the
misfire c ...


